*Available Q3 2025 - please enquire RAV.SG.SRC.IO is a dual audio network module for the PRODIGY Series and MAVEN.A to interface with 64 channels each of RAVENNA and SoundGrid streams. One module, two audio engines Hosting two audio network boards the module offers 2 x 64 of two different audio protocols - RAVENNA and SoundGrid. This allows to interface with two audio protocols in a single A Slot of MAVEN.A or PRODIGY.MC. With the two A Slots of a PRODIGY.MP the coverage can be extended by a third or even fourth audio protocol. Sample Rate Conversion Individual HD SRC for bi-directional sample rate conversion is on board as a standard. The PRODIGY and MAVEN Series also offers low latency sample rate conversion (FastSRC) for input and output. The two audio network boards can be operated at different sample rates. Dual network modules ensure a seamless connection across clock boundaries and different audio protocols on a single module. Stream Redundancy There are 2 x 2 independent network interfaces to connect each protocol via a second stream (Port 1 / Port 2). The amount of audio channels per protocol is reduced at higher sample rates - 32 channels @ 2 FS or 16 channels @ 4 FS (SoundGrid supports 1 FS and 2 FS only). RAVENNA is an open audio networking technology developed initially by ALC NetworX. DirectOut's own RAVENNA implementation relies on more than ten years of development. As a successful participant of the JT-NM Tested program RAV.IO is listed in the JT-NM Tested Catalog as a module aligning with the SMPTE 2110 standards. SoundGrid is an audio networking technology from Waves that is based on ethernet layer 2. Key features RAVENNA 32 streams 64 channels (1 FS), 32 channels (2 FS), 16 channels (4 FS) 500 ms buffer (WAN capable) Sample rate 44.1 kHz up to 192 kHz Sample rate conversion (HD SRC on board, FastSRC™ in PRODIGY / MAVEN Series) Stream redundancy ST 2022-7 Switch configurable (NIC1 & NIC2) Compliant with AES67, SMPTE ST 2110-30 / -31 Ethernet layer 3 ('Audio over IP') 2 x RJ45 gigabit ethernet PTP Hybrid Mode Remote control via browser and globcon NMOS IS-04 (stream discovery) NMOS IS-05 (connection management) Key features SoundGrid 64 channels (1 FS), 32 channels (2 FS) Sample rate 44.1 kHz up to 96 kHz Sample rate conversion (HD SRC on board, FastSRC™ in PRODIGY / MAVEN Series) Ethernet layer 2 2 x RJ45 gigabit ethernet Remote control via SoundGrid Studio, browser and globcon

ANDIAMO is a powerful, high-end AD/DA converter offering simultaneous conversion of 32 audio channels from analog to digital and vice-versa and sharing the extremely high sonic quality with the PRODIGY Series. The third generation of ANDIAMO takes the features that made the product famous worldwide and expands them to reach a new level. Housed in an elegant, space-saving 1U 19” casing, it allows conversion to and from MADI via two SFP ports, while the optional network audio cards support RAVENNA/AES67, Dante, SoundGrid or AVB/MILAN *applied for certification This item is: 128ch Soundgrid Option Board

The Glensound BEATRICE D16 is a versatile and fully featured 16 channel desktop intercom with crystal clear audio designed for broadcast, theatre and professional audio applications. • 16 Channels Of Intercom One single user connected to the unit can listen to and communicate with 16 separate locations on the network. Depending upon how the Dante network has been routed the incoming audio circuits and outgoing circuits can be different locations. • Dante® Routing & Partyline Audio routing to/ from other devices is setup using Dante controller which allows for point to multipoint routing on outgoing circuits (but only 1 single incoming circuit for each of the 16 channels). Therefore we’ve included an inbuilt fixed ratio 11 input 11 output mixer matrix with inputs and outputs connected directly to the Dante® / AES67 network which allows for setting up partyline and group circuits. • Onboard Mic & External Mic Input A good quality, clear sounding microphone amplifier, designed for communication purposes, is fitted which also has the benefit of a compressor/ limiter circuit to help keep levels and intelligibility consistent even when the operator gets overly excited. This microphone amp has two microphone sources, either the inbuilt front panel mounted electret capsule which provides good voice intelligibility from normal working distances, or a balanced XLR input for connecting external gooseneck microphones. Twelve Volt Phantom power is also available and can be turned on/ off as required via an internal link. • High Output Intelligible Loudspeaker What’s the point of an intercom unit if the onboard speaker is so cheap that you can’t understand what is being said to you? We tried many different drive units before settling on the one used in the Beatrice D16. We chose it because it has a much cleaner sound and better frequency response for vocals. • Mains or PoE Powered An inbuilt wide range switch mode mains power supply is fitted for powering the Beatrice D16. It is terminated with a standard IEC plug, making it easy to plug in wherever you are in the World. The unit can also be powered via the Ethernet cable by standard PoE (Power over Ethernet) on either of the copper Ethernet ports. The PoE power can be supplied by an external PoE switch or a midspan power injector. • Redundant Twin Copper & Twin Fibre Ethernet Interface When ultra reliable communications is needed for the utmost important jobs, glitch free redundant network circuits can be set up using the primary and secondary Dante network ports. There are 2 copper Ethernet ports on RJ45s and also 2 fibre Ethernet ports presented as SFP slots (SFP modules not included). Redundant networks can be set up across any of these ports. These ports can also be setup as a network switch. • GPIO A solid state relay output is provided and is triggered when any speak key is on (useful for dimming external loudspeakers or red light controls). In total there are 12 loop closure inputs. 10 of these control the first 8 talk keys and talk to group and talk to all. The other 2 loop closure inputs provide internal & external LS cuts. • IFB/ AUX Sources Four different IFB/ Aux audio sources are received from the Dante network. Each of the four sources is associated with four outgoing talkback channels. If audio is routed to the(se) IFB/ Aux source(s) in the network then they are mixed in with their associated outgoing talkback channel circuit. If a talkback key is on then the associated IFB/ Aux source is ducked by 20dB. If the talkback is not on then the IFB/ Aux source is routed to the channel's output with unity gain. IFB/ Aux sources are very useful for distributing programme audio around an intercom setup whilst the ducking facility allows talkback to be heard over it. • Microphone Level Meter An eight LED front panel multipurpose indicator is used to indicate the outgoing microphone level. • Channel Input and Output Gain Controls For maximum flexibility gain can be applied to incoming audio signals and outgoing signals separately. A row of LEDs indicate the current gain setting when a channel's input or output is being adjusted. • Monitor All incoming talkback channels are mixed together to the headphones/ loudspeakers. • Presence Indication Front panel LEDs located next to the talk switches are used to indicate the presence of incoming audio on that channel. When audio is detected on the channel the LED is illuminated, the LED then stays on for a short period after the incoming audio stops to help the operator identify who has been talking to them. • Speak To All and Speak To Group Two useful front panel controls are fitted. When pressed, the ‘Speak To All’ button will enable the operator to talk to all the outputs simultaneously and the ‘Speak To Group’ button allows the operator to talk to an easily assignable set of outputs. • Speaker Output As well as the front panel internal loudspeaker a balanced analogue output is provided for connecting to an external powered loudspeaker. • Mixer Matrix For Partyline For setting up simple groups and partyline circuits that could not be achieved via Dante® controller or your AES67 router, an inbuilt fixed ratio mixer is supplied. It has 11 audio inputs direct from the network and 11 mix outputs to the network. It is part of our Beatrice intercom system that utilises the reliable and proven Dante® network audio transmission protocol to allow real time distribution of uncompressed audio across standard networks. It is also AES67 compliant. As such the BEATRICE D16 is fully compatible with other manufacturers’ equipment using the Dante® and/ or AES67 protocols. This sixteen channel desktop intercom was designed to be very easy to use for the operator and simple to set up for the technician. It includes all the basic functionality required for small intercom systems and none of the overly complex installation requirements normally associated with large systems.

When your project requires a powerful performance with no sacrifice in quality, the Genelec 8030C active studio monitor is designed to exceed your expectations. The 8030C, introduced in 2017, even delivers 4 dB higher SPL and has a lower energy consumption than earlier models of 8030. As strikingly stylish as it is sonically impressive, the 8030C features the rounded edges and colour-free, accurate reproduction of the rigid all-aluminium Minimum Diffraction Enclosure (MDE™). Every element of the design is crafted to perfect your listening experience. Precise on- and off-axis frequency reproduction is courtesy of the Directivity Control Waveguide (DCW™). Broad low-frequencies and high SPLs are delivered with a flow-optimised internal curved reflex tube and a maximised internal volume. And when you’re finished, Genelec Intelligent Signal Sensing (ISS™) circuitry detects when your system is no longer in use, placing it into an environmentally friendly, power-saving standby mode. From professional studios to outside broadcast vehicles, the 8030C has been crafted to combine extraordinary power with absolute precision.

ANDIAMO is a powerful, high-end AD/DA converter offering simultaneous conversion of 32 audio channels from analog to digital and vice-versa and sharing the extremely high sonic quality with the PRODIGY Series. The third generation of ANDIAMO takes the features that made the product famous worldwide and expands them to reach a new level. Housed in an elegant, space-saving 1U 19” casing, it allows conversion to and from MADI via two SFP ports, while the optional network audio cards support RAVENNA/AES67, Dante, SoundGrid or AVB/MILAN *applied for certification This item is: 64ch Dante AoIP Option Board

Analog 0.5m long patch cable for connection between Analog DSub25 connectors on ANDIAMO, PRODIGY and BREAKOUT.AN16i or AN16O (AES59 Analog Tascam format), transferring 8 audio channels

3-Dimensional Steerable Column Speaker Features: • Operating Bandwidth +0/-3dB: 100Hz-20kHz • On Board Amplification 81x 30W, 9x 200W • On Board DSP: 90 Channels • Capable of being clustered horizontally and vertically to form larger arrays • Can be mounted both vertically and horizontally • Vertical and horizontal pattern coverage adaptable from 1 degree through to 150 degrees to maximize sound quality by restricting sound to a listener area to avoid reflected sound • Pan and tilt adaptable down to 0.1-degree resolution, up to 50 degrees off axis, to allow for easy and visually pleasing installation • Symmetrical, asymmetrical, and complex custom 3-D wave fronts possible • Capable of acoustic skew to throw higher sound pressure levels (SPL) over longer distance to improve SPL consistency in a space • Hight SPL capacity • Capable of producing 4 unique beams of sound in different directions, with differing acoustic shape • Weatherproof options • High bandwidth coherence from 100Hz-20Hz • Highly musical performance with excellent speech clarity • Ethernet network control and monitoring with feature rich DSP (EQ, dynamics, mixing) • High acoustic redundancy for increased reliability • On board amplification and processing • Suitable for live musical performance, installations, rental, touring, transport terminals, speech, under-balcony fill and heritage listed buildings

MILAN.SRC.IO is an audio network module* for the PRODIGY Series and MAVEN.A to interface AVB/Milan streams. Compared to MILAN.IO the MILAN.SRC.IO features sample rate conversion (HD SRC) on board. The PRODIGY and MAVEN Series also offers low latency sample rate conversion (FastSRC™) for input and output. Two redundant gigabit network interfaces with RJ45 or SFP connect up to 128 audio channels (input / output) through an internal switch. The amount of audio channels is reduced at higher sample rates - 64 channels @ 2 FS or 32 channels @ 4 FS. Milan is an audio networking technology created and maintained by Pro Audio market leaders in the Avnu Alliance®. Milan™ is a standards-based deterministic network protocol for real time media. * applied for certification

Unbalanced Analogue Duagn Automixer APPLICATIONS: News panels, sports commentary Conference reinforcement, video trucks Film and television dialogue, reality shows Multiple wireless mics for theatre Boardrooms, civic meeting rooms, community TV Teleconferencing and distance learning Houses of worship FEATURES: Eliminates late upcuts Reduces PA feedback and studio noise Eight channels analog or sixteen channels digital Dugan Control Panel for Java included Channels may be grouped into three independent auto mixers Half-rack size — mount two in one RU Link up to eight units for up to 128 channels

Three-way Smart Active Monitor (Dark Grey). The 8341A is the point source monitor with the perfect blend of size and performance. For applications calling for extraordinary imaging, extended frequency response, short to medium listening distance or long, fatigue-free working hours, The Ones are in an elite league of their own. They promote faster and more consistent decision making, and they also extend listening time, because unnatural imaging - a main contributor to listener fatigue - is minimised. As bigger brother to the super-compact 8331A, the 8341A offers increased LF extension and a higher SPL capability, so is ideally suited to slightly longer listening distances. In conjunction with our GLM calibration software, the 8341A will also compensate for detrimental room acoustics and distance delay, regardless of whether you work in mono, stereo or immersive formats. So now you can deliver mixes that translate beautifully - every time.