You’ll come across many houses at present that can boast of having solar panels for converting solar energy into electricity. However, the installation process of these panels might be somewhat intimidating since they appear to be more complicated than they are. To make things easy for you, here, we have explained several steps that will help you install solar panels Sydney in the best possible way.

1. Choosing the mounting location

It is vital to select the proper location for mounting the devices. You might not have adequate space in your residence, and in that case, it will be a good idea to place the panels on the roof. On the other hand, a pole mount installation might be suitable for you in case you are the owner of a vast area of land.

It is vital to make certain that the panels will have uninterrupted and constant access to sunlight irrespective of what mounting location you choose. However, it will be a good idea to avoid trees and other obstacles that might cast shadows on these panels.

Moreover, it is vital to install the panels in the right direction. Inspect your roof to decide the best side or area for getting maximum exposure to the sun. In general, the panels should be facing the opposite direction from the hemisphere where you are residing.

2. Installing the panels

It is time for you to secure the railing and metal racks after installing the mounting hardware for residential solar panels Sydney. It is important to be certain that water will be able to run and wind will be able to flow adequately below the panel after installation. Because of this, it will be a good idea to install the panels at a height of at least 3 inches from the roof. After getting the racks, hardware, and rails in the proper position, it is time for you to go for solar panel installation. Make use of restraining hardware for securing the panels into position. The time is not perfect for you to connect these panels in case you want to install more than one.

3. Figuring out the appropriate tilt angle

It will be advisable for you to tilt the panels once they have been installed for receiving optimum exposure to sunlight. Figure out your home’s latitude for calculating the appropriate angle. In case you are in doubt, you will find information about it on the Internet.

After finding the proper latitude, make sure to subtract or add 15° to the number which will depend on the system. Minimize the number by 15° so that they become more vertical during summertime. On the other hand, add 15° during winter so that the panels are angled more in the direction of the horizon. This will allow your panels to receive more sunlight all through the year.

Source: https://bit.ly/3bWdyf7