Roller Blinds Motor Factory introduces the hanging steps of electric curtains:

Step 1: to determine the number of hanging loops and hooks required by each side of the electric curtain, as long as the number of hanging loops is confirmed first, sufficient preparations can be made.

Step 2: First, the curtains are folded in half, then folded in half, and folded in half again until you see the head, and then the center of the folded fold is the center of the hanging ring and hook. Count the center of the folded fold to be smaller than Equal to the number of hanging loop hooks you have in hand.

Step 3: After the electric curtains are hung, when the electric curtains are drawn, pull the electric curtains to the middle, and then a hanging ring will be stuck, which can ensure that the electric curtains will not all run to the middle.

Step 4: The hooks on both sides of the rods are installed, then the middle hooks must be installed to hook the rods. If the middle position is selected crooked, then the electric curtain will cause one side not to be fully opened, and the other side to be fully opened. phenomenon that is not enough.

Through the above introduction, Awning Motors Exporter hopes that you can simply refer to the content of this article in future use.